Best Clasps For Holding Rope Lighting

Our solderless waterproof 10mm (SMD5050) RGB LED light strip connectors are a simple, frustration-free solution for waterproof 5050 RGB LED light strip connection and extension needs.

Installation Instructions:
1.Ensure your section of LED light strip is WATERPROOF SMD 5050 LED Strip and has 4 contacts (+, B, R, G) and all the contacts are clean.
2.When you cut your LED strip from the cutting line, please preserve the area of each copper contact on the LED strip to be bigger than the area of each corresponding pin in the connector. This is a very important step to ensure good conductivity between the connector and the LED strip.
3.Open the white clasp of the connector.
4.Peel off the 3M tape around the soldering/Cutting line area on the back of the LED strip, then insert the LED light strip into the clasp, with the 4 contacts of the led strip sitting ON the 4 pins of the clasp – make sure to match the + side of the strip to the + side of the clasp; (Note: There is no need to peel off the silicone on the surface of led strip around soldering line area.)
5.Close the clasp.
6.Your connection is successfully made!

Package includes: 10x 4-pin connectors for 10mm wide Waterproof RGB 5050 LED strip.

Our single color smd 3528 LED light strip clip connectors are a simple, frustration-free solution for all of your flexible LED light strip and tape light connection and extension needs. These connectors install with a simple clasp attachment, meaning that you can easily achieve a safe and secure connection. Suitable for all LED light strip applications including kitchens, cabinets, bedrooms, shelving, ceiling up lighting, and displays.

These cables and accessories come in a variety of lengths and styles to meet your strip and ribbon lighting needs, including gapless, wired lengths from 6 inches to twelve feet, and strip to female DC barrel jack for connecting to your driver, power adapter cord or splitter. Suitable for any 8mm indoor, outdoor, or waterproof LEDs ( 12 volt and 24 volt ).

Six Inch Any-Angle Strip-to-Strip Connector (4 Pack)

Instructions:
Cut your LED strip on a cut point
Open the plastic clasp on the connector
Insert the LED light strip under the prongs – making sure to match the + and – on the strip to the + and – on the clasp
Close the clasp
Your connection is made!

Our connectors and extensions are fully bendable and are perfect for extending a run of LED light strip across a gap, around an obstacle, or for making a bend, including L shape right angle bends. See our full range of connectors and jumpers to connect to low-voltage electronic dimmers, power supplies, adapters, or a controller.

Specifications :
Internal Width : 8 mm (compatible with any 2-pin strips)
External Dimensions : 13.5 x 12.5 x 5 mm (5/8 x 1/2 x 3/16 inches)
Length : 6 inches
Gauge : 22 AWG
Part Number : CON-08S-B00A-4PK

Specs:
1.Length: 50Ft
2.Color: Blue
3.Tube Diameter: 3/8″
4.LED Quantity: 360
5.Rated Lifespan: 50000h
6.Working Temperature: -20~50°C
7.Power Consumption:27W-32.4W
8.Voltage: 110V

Package Includes:
1x 50Ft Rope Light
1x SparePower Cords with Connectors
15x Clips

Hi,friend.Welcome to “Fan-Ling”, please reading the product description and key product features carefully before buying.And there are a series of Practical product in our store,you can have a look.♪(^∇^*)

Ready to work:

1. a one-time cup: thicker, bigger, transparent the best (if the baby does not put in, you can consider the cup of tea)

2.30-35 degrees pure water or tap water (please do not use mineral water)

3. chopsticks

4. Spoon

5. Thermometer

6. Stopwatch: mobile phones, computers are, you can watch the clock

Steps:(usually within one year of the baby a hand 50 grams, one foot 100 grams)

1. Take clone powder 50 grams, add 1.2-1.5 times the volume of water mixed, rapid mixing, then cloning powder and water mixture into a purple paste liquid, stir it, about 1 minute or so purple gradually receded, immediately Baby’s little hands or feet into the liquid, the baby’s little hands or feet must be soaked in the liquid inside, do not stick to the walls of the cup, while ensuring that the baby’s hand or feet do not move, about 2 and a half times the liquid will solidify, please Keep 4 minutes and then remove the baby’s hand or feet, can be removed before and after the move, let the air go, slowly removed.

2. Take the model powder 50 grams, add 1 / 3-1 / 2 of water, water do not put too much, as long as the powder and water mixture into a liquid, the more concentrated the better, even after mixing, slowly poured into the colloid , Down a little, Akira look, to avoid the gas plug in the inside.

3.2-5 hours after the knife or hand can be used to slowly open the colloid, must be carefully poke, not anxious.

(Note: the surface of the work of a little powder can be rinsed with water, placed in a ventilated place to dry, it is recommended to dry for more than 24 hours.)

4. Color: like to paint what color to give their own works painted what color it

Package Co

JENIA’s durable quality 24” chain necklace locket pendant has 8 reusable felt pads in beautiful color variants.
You will love how these pads creatively enhance the looks of the pendant locket every time you put in one of them.
This is because the felt pads do a lot more than retaining favorite oils in the felt pads,
they also help to complement any style of your dress, any day and for any occasion!

JENIA’s aromatherapy oil diffuser magnetic locket pendant with free 24” chain necklace
offers immense benefits such as helping to carry along with you the sweet fragrance of your favorite essential while you go about your day-to-day activities.
It also contributes to keeping you calm during your plane ride and helping you maintain absolute focus and peace of mind when you need them the most!

Specially crafted with you in mind, JENIA’s aromatherapy oil diffuser magnetic locket pendant with free 24” chain necklace is comfortable!
You never have to worry about the oils smearing on your dress or coming in direct contact with your skin.

The perfect finishing and gorgeous appeal of JENIA’s essential oils jewelry’s and its cute velvet pouch makes the product a perfect gift item
for anyone who is in love with aromatherapy jewelry and accessories including boys, girls, and children.
It is perfect for graduation ceremonies, birthdays, Christmas and other gift giving celebrations and holidays

What’s more? Every unit of
JENIA’s aromatherapy jewelry is trusted for its superior quality, improved durability, better corrosion resistance and hypoallergenic properties.

We’ll replace or refund if it is defective, breaks or you are not satisfied – no risk no problem when you order today.
Click the “ADD TO CART” button at the top of the page to Order your Aromatherapy Jewelry Now!

Magnetic Clasps are great for people who have long nails, arthritic or otherwise have difficulty using the regular jewelry clasps. That is if they do what they promise; not lose your necklaces, turn your neck green or cause allergies. This clasp is 14k Gold-filled with very powerful magnets Made in in the USA, and much better quality and finish than that of competing look-alikes. and because we use a bigger Spring-Ring clasp they can be attached (or detached) to just about any necklace quickly and easier than that of our competition. The only word of caution is that, the heat from boiling water (150F or above) will diminish the strength of the magnets, so its best to detach them before cleaning your jewelry in ultrasonic cleaners. Regarding GOLD-FILLED, its made with thin sheet of real gold bonded to another metal (mostly Brass) and its much, much better than plating and it should last for years, but its not permanent as solid gold and will eventually wear out.. This Clasp is the sma